single phase 8.0 amp bridge rectifiers maximum ratings and electrical characteristics rating 25 c ambient temperature uniess otherwies specified. single phase half wave, 60hz, resistive or inductive load. for capacitive load, derate current by 20%. type number maximum recurrent peak reverse voltage maximum rms voltage maximum dc blocking voltage maximum average forward rectified current .375"(9.5mm) lead length at tc=50 c dimensions in inches and (millimeters) fe a tures peak forward surge current, 8.3 ms single half sine-wave superimposed on rated load (jedec method) maximum forward voltage drop per bridge element at 4.0a d.c. maximum dc reverse current ta=25 c at rated dc blocking voltage ta=100 c storage temperature range, tstg operating temperature range, tj GBU8005 gbu801 gbu802 gbu804 gbu806 gbu808 gbu810 units 50 100 200 400 600 800 1000 v 50 100 200 400 600 800 1000 v 35 70 140 280 420 560 700 8.0 20 0 10 500 -50 +150 -50 +150 v a a v u a m u a c c * ideal for printed circuit board * low forward voltage * polarity: marked on body * mounting position: any GBU8005 thru gbu810 1.1 voltage range 50 to 1000 volts current 8.0 ampere * low leakage current gbu .752(19.1) .720(18.3) (.874) (.860) 22.2 21.8 .720(18.29) .680(17.27) ac .232(5.9) .224(5.7) .1 7 3 ( 4 . 4 0 ) .1 3 4 (3. 4 0 ) .083(2.1) .075(1.9) .022(.56) .018(.46) .210 .190 .210 .190 .210 .190 (5.33) (4.83) (5.33) (4.83) (5.33) (4.83) + * both normal and pb free product are available: * normal:80~95%sn,5~20%pb * pb free:99 sn above can meet rohs enviroment substance directive request
rating and characteristic curves (GBU8005 thru gbu810) fig.4-typical reverse characteristics fig.1-typical forward current average forward current,(a) fig.2-maximum non-repetitive forward surge current peak forwaard surge current,(a) 2 4 6 8 10 12 20 0 single phase half wave 60hz resistive or inductive load case temperature ( c) derating curve fig.3-typical forward characteristics 0 25 50 75 100 125 150 175 number of cycles at 60hz 1 10 5 50 100 tj=25 c single half sine wave jedec method with heatsink without heatsink 0.1 1.0 10 1000 fig.5-typical reverse characteristics 0 20 40 60 1.0 4.0 10.0 100 1.0 10 100 1000 0 0.2 0.4 0.6 0.8 1.0 1.4 1.6 0.1 1.0 10 100 100 tj=25c tj=50c tj=100c tj=125c instantaneous reverse current,(ua) percent of rated peak reverse voltage,( ) instantaneous foeward voltage ,volts instantaneous foeward current ,(a) tj=25 c ,f=1mhz reverse voltage,volts capacitance,(pf) 80
|
